Honeywell GKP-S8M User Manual page 11

A double beep is played and all LEDs light on.
2. Enter the master code or present the master tag.
A high beep is played and all status LEDs start flashing.
3. Enter the code for the new user. A high beep is played.
4. Re-enter new user's code. A high beep is played.
The programming mode ends automatically.
5. After a few seconds, a double beep is played and all status
LED stop flashing.
To disable a user's code:
To disable a user's code and keep the TAG only:
1. Press and hold the user number "0 to 9" key for 3 seconds (1
is the master).
A double beep is played and all LEDs light on.
2. Enter the master code or present the master tag.
A high beep is played and all status LEDs start flashing.
3. Change the code to 0000 (or 000000 if 6 digits).
4. Re-enter the code 0000 (or 000000 if 6 digits).
A high beep is played.
5. After a few seconds, a double beep is played and all status
LED stop flashing.
To disable a user:
1. Press and hold user number "0 to 9" key for 3 seconds.
Note: it is not possible to disable the master user.
A double beep is played and all status LEDs light on.
2. Enter the master code or present the master tag.
A high beep is played and all status LEDs start flashing.
3. Press the
The programming mode ends automatically.
4. After a few seconds, a double beep is played and all status
LED stop flashing.
10
key to disable the user.