Arming Using Your Code Or Tag - Honeywell GKP-S8M User Manual

Arming using your code or tag

Press an arming key on the keypad and enter the code or present
a programmed TAG.
+
When the keypad is dedicated to the annex set only, the
key will arm the annex set and the
Arming can be performed with or without user identification
depending on the panel setup.
The arming tone is emitted by the keypad followed by the exit
delay beeps. If a perimeter fault is signalled on arming, disarm
the system before checking all the doors and windows equipped
with contacts.
The zone set arming is completed automatically at the end of the
delay (depending on your system configuration).
Notes:
Always make sure that your Total arming request is followed
by the arming tone.
Holding the TAG less than 1 minute in front of the keypad will
not reverse the status.
If a detector is parameter in final door, Total set arming is
completed after you close the final exit door. After the door is
closed, the exit delay beeps stop and the 'arming complete' tone
is emitted by the panel and keypad siren. For Partial, the zone set
arming is completed automatically at the end of the delay.
4
Arms the total set
Arms the partial set
Arms the annex set
(the keypad must be associated with Total
+Annex)
key will be disabled.