Makita BHP460 Instruction Manual page 8

FUNCTIONAL DESCRIPTION
Installing or removing battery cartridge
Always switch off the tool before insertion or removal of the battery cartridge.
To remove the battery cartridge, with-
draw it from the tool while sliding the
button on the side of the cartridge.
To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Always insert it all the way until it
locks in place with a little click. If you can
see the red part on the upper side of the
button, it is not locked completely. Insert
it fully until the red part cannot be seen. If
not, it may accidentally fall out of the tool,
causing injury to you or someone around
you.
Do not use force when inserting the battery cartridge. If the cartridge does not slide in
easily, it is not being inserted correctly.
Charging
1. Plug the battery charger into your power
source. Two charging lights will flash in
green color repeatedly.
2 . Insert the battery cartridge into charger
until it stops adjusting to the guide of
charger. Terminal cover of charger can
be opened with inserting and closed
with pulling out the battery cartridge.
3. When the battery cartridge is inserted,
the charging light color will change from
green to red and charging will begin. The
charging light will keep lighting up lit
steadily during charging.
One red charging light indicates charged
condition in 0-- GO% and two red on& indicates 80
-
100Y0.
ones.
The charging time is as follows:
Battery 8241 7: approx. 30 minutes.
Battery 82430: approx. 60 minutes.
5.
If you leave the battery cartridge in the charger after the charging cycle is complete, the
charger will switch into its "trickle charge (maintenance charge)" mode which will last
approximately 24 hours.
4. With finish of charge, the charging lights will change from two red ones to two green
6. After charging, unplug the charger from the power source.
8