Makita HR2631F Instruction Manual page 8

Press the lock button on the grip base in the direction of arrow
shown in the figure and with the lock button being pressed
insert the depth gauge into the hex. hole in the grip base
1
2
015348
At this time, the depth gauge needs to be inserted so that
its toothed side is directed to the toothed side of hex hole
marking on the grip base as shown in the figure.
1
015349
Adjust the depth gauge to the desired depth by moving it
back and forth while pressing the lock button. After the
adjustment, release the lock button to lock the depth gauge.
1
015350
NOTE:
Inserting the depth gauge with its toothed side not
•
directed to the toothed side of hex hole marking on
the grip base as shown in the figure does not allow
the depth gauge to be locked.
Dust cup (optional accessory)
1
010731
1. Toothed side of
hex hole
marking on the
grip base
2. Toothed side of
the depth gauge
1. Lock button
1. Toothed side of
hex hole
2
marking on the
grip base
2. Toothed side of
the depth gauge
1. Dust cup
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in
the figure. The size of bits which the dust cup can be
attached to is as follows.
Dust cup 5
Dust cup 9
006406
There is another type of dust cup (optional accessory)
which helps you prevent dust from falling over the tool
and on yourself when performing overhead drilling
operations.
Installing or removing the dust cup
(optional accessory)
1
3
015351
Before installing the dust cup, remove the bit from the
tool if installed on the tool. Install the dust cup (optional
accessory) on the tool so that the
dust cup is aligned with the grooves in the tool.
1
015352
To remove the dust cup, pull the chuck cover in the
direction as shown in the figure and with the chuck
cover pulled take the bit out of the tool.
1
015353
And then grab the attachment at the foot of dust cup
and take it out.
8
Bit diameter
6 mm - 14.5 mm
12 mm - 16 mm
1. symbol
2
2. Grooves
3. Dust cup
symbol on the
1. Bit
2. Chuck cover
2
1. Attachment at
the foot of dust
cup