Makita MAC2000 Manual page 16

Tank pressure exceeds preset
pressure switch limit
Motor overload protection
has
tripped
Fuse blown or arcuit breaker
tripped
Check valve stuck open
Pressure bleeder valve on
pressure switch has not unloaded
head pressure
Wrong wire gauge in
cord
or
excessive extension mrd length
Loose electrical connections
Possible defective capacitor
Paint spray on internal motor
Parts
Possible defective motor
Motor will start automatically when tank pressure drops below
kid-in pressure of pressure switch.
Let motor cod
off,
and overload switch will automatically reset.
This may take several minutes.
0
Reprace
blown fuse or reset circuit breaker.
Do
not use
fuse
or circuit breaker with higher rating than that specified for your
branch circuit
0
Check for proper fuse; 'Fusetron' type T is acceptable.
0
Check for low voltage and proper extension cord size.
0
Disconnect other appliances from circuit Operate compressor
on a dedicated circuit
Remove and dean or replace.
Bleed line by moving pressure switch lever to OFF position
before restarting. If bleeder valve does not open, replace
bleeder vdw.
Chedc for
proper
gauge and extension cord length.
Contact
authorized service center.
~~
Have checked at service center. Do not operate the compressor
in the paint spray area.
Have checked at service center.
16
200-2 729