Setting Up Your Router For Internet Access - NETGEAR WNR2000V3 Setup Manual

Figure 12

Setting Up Your Router for Internet Access

When configuring your wireless router manually, you must log in to your wireless router to set it
up initially and to make any changes to your wireless router's settings later.
The factory default state is reset when you use the Restore Factory Settings button.
See "Restoring the Default Password and Configuration Settings" on page 36
more information.
To access the router:
1. Type http://www.routerlogin.net in the address field of your browser, and then click Enter.
You can enter either of these addresses to connect to your wireless router:
http://www.routerlogin.net or http://www.routerlogin.com.
Manually Installing Your Router
Power. The power light should turn solid green. If it does not, see
"Checking Basic Router Functions" on page
Internet. The Internet port light should be lit. If it is not, make sure the
Ethernet cable is securely attached to the wireless router Internet port
and the modem, and that the modem is powered on.
Wireless. The wireless light should be lit after turning on the wireless
router.
LAN. A LAN light (1-4) should be lit for each connected computer on
your network. Green indicates that your computer is communicating at
100 Mbps; amber indicates communication at 10 Mbps. If a LAN light is
not lit for each connected Ethernet cable, make sure that the Ethernet
cable from the computer to the router is securely attached at both ends,
and that the computer is turned on.
WPS. The WPS button/light will not be lit unless you push it to enable
Push 'N' Connect (WPS) security. See
to Configure Your Wireless Network" on page
27.
"Using Push 'N' Connect (WPS)
23.
for
17