Setting Up Your Router For Internet Access - NETGEAR WNR2200 - N300 Wireless Router Setup Manual

• LAN. At least one LAN light (1) should be lit. Green indicates that your computer is
communicating at 100 Mbps; amber indicates 10 Mbps. If a LAN light is not lit, check that the
Ethernet cable from the computer to the router is securely attached at both ends, and that the
computer is turned on.
• USB. The USB light (3) should be lit if a USB device is connected and ready to be used.
• WLAN On/Off. The Wireless Local Area Network (WLAN) button (5) turns the wireless
function on and off.
• WPS. The WPS button (6) turns the WPS function on and off. Be sure the WLAN button is
turned on before turning on the WPS button.

Setting Up Your Router for Internet Access

When configuring your wireless router manually, you must log in to your N300 wireless router to
set it up initially and to make any changes to your wireless router's settings later.
The factory default state is reset when you use the Restore Factory Settings button.
See "Restoring the Default Password and Configuration Settings" on page 40
more information.
To access your router:
1. Connect to the N300 wireless router by typing http://www.routerlogin.net in the address
field of your browser, and then press Enter.
Figure 9
Connect to the N300 wireless router by typing any one of these three URLs in the
address field of your browser, then pressing Enter:
http://www.routerlogin.net
•
http://www.routerlogin.com
•
• http://192.168.1.1
Installing Your Wireless Router Manually (Advanced and Linux Users)
for
15