Brother Model KH--830 Service Manual page 35

6 . Mounting
the machine
body into the
case
7. Mounting the accessories box 8. Mounting
the
needle selector panel
Name of parts
~
®·s
6.1 Keep the machine body in the case. Left part Is first.
6.2 Tighten two right clarnpina screws and the equal number of
left clamping screw for the needle bed .
6.3 Put the right and left leaf springs in position of the needle bed
upper plate and fasten with needle bed upper plate clamping
screws.
6 .4 Tighten three clamping screws for the ease reinforcing plate
A and cax reinforcing plate B.
6.5 Fit the right and left machine body
fitting
plates onto the
back
side
of the case with two clamping screws for right and
left fittfn, plates each.
-33-
®·2
®
Lo'VIIC-r Cite
Fig. 33
Needle bed clamping
screw
Needle bed upper
plate clamping
SCJCW
Case reinforcing plate
clamping screw
Machine body fitting
plate clamping screw
Accessories box
clamping screw
Direction indicator
Needle selector panel
clamping SCJew
Card stop lever knob
7 .I Keep the accessories box
at
the left side of the machioe
body and fasten with clamping screw~.
8.1 lnselt the direction indicator ( plas!ic-made) into the clutch
wheel shaft.
8.2 Keep the needle selector panel at
the
right side of the machine
body and fasten with shree needle selector panel clamping
screws.
8.3 Insert the cu d stop lever linob into the lever.