Table of Contents
Advertisement
Problem
My steam generator
doesn't heat up.
My steam generator
does not produce any
steam.
Water droplets come out
of the soleplate.
My steam generator
occasionally makes a
strange sound.
Dirty water comes out of
the soleplate.
Possible cause
Your steam generator is not
connected properly.
Your steam generator is not
switched on.
The temperaure is set to
MIN.
There is not enough water in
the water tank.
Your steam generator's
boiler is still heating up.
The selected temperature is
too low for steam ironing.
The water tank is not fitted
correctly.
The steam may not be
visible if your steam
generator is set to a high
ironing temperature.
The selected temperature is
too low for steam ironing.
If you have left your steam
generator for some time
between ironing, steam
left in the steam hose can
cool down and cause water
dropets to form.
This is the internal pump
transferring water from the
water tank as required.
Scale and other impurities
have accumulated inside
the boiler of your steam
generator.
troubleshooting
Solution
Check the mains power cord,
plug and wall socket.
Press the on/off switch to
switch your steam generator
on.
Set the temperature to the
required temperature.
Fill the water tank as
required.
Wait until the steam indicator
light stops flashing and goes
out.
Set the temperature to
higher.
Check that the water tank is
correctly fitted.
Set your steam generator to
a lower temperature (e.g.
to check if steam is being
produced.
Set the temperature to
higher.
This is normal. Hold your iron
over an old cloth and press
the steam trigger until steam
rather than water droplets
come from the soleplate.
This is normal.
Allow your steam generator
to fully cool down then rinse
the boiler—see care and
cleaning on page 16.
or
ll
)
ll
or
ll
11
Advertisement
Table of Contents
