Overall length................................................................................................................................ 433 mm (17")
Net weight ................................................................................................................................ 6.0 kg (13.2 lbs)
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only
be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can,
therefore, also be used from sockets without earth wire.
Page 1
Disc Grinder 230 mm (9”) MODEL GA9000 DOUBLE INSULATION SPECIFICATIONS Model GA9000 Depressed center wheel diameter ....................230 mm (9”) No load speed (min ) ..........................6,500 Overall length..........................433 mm (17”) Net weight ..........................6.0 kg (13.2 lbs) • Due to our continuing program of research and development, the specifications herein are subject to change without notice.
15˚ 30˚ Symbols The following show the symbols used for the tool. Be sure that you understand their meaning before use. ❏ Read instruction manual. ❏ DOUBLE INSULATION...
21. Warning. 20. Do not touch the workpiece immediately after operation; it may be extremely hot and could The use of any accessory or attachment, other burn your skin. than those recommended in this instruction man- 21. Position the tool so that the power cord always ual or the catalog, may present a risk of personal stays behind the tool during operation.
To remove the wheel , follow the installation procedure in replaced at the same time. reverse. To maintain product safety and reliability, repairs, mainte- nance or adjustment should be carried out by a Makita Switch action (Fig. 6) Authorized Service Center. CAUTION:...
Page 7
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner.
Page 8
• Dust collecting wheel guard Makita Corporation Anjo, Aichi, Japan Made in Japan 883253D078...