Related Manuals for Makita GA7020Y
Summary of Contents for Makita GA7020Y
- Page 1 INSTRUCTION MANUAL Angle Grinder GA7020 GA7020S GA7020Y GA9020 GA9020S 010853 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model GA7020/GA7020Y GA7020S GA9020 GA9020S Depressed center wheel diameter 180 mm 230 mm Spindle thread Rated speed (n) / No load speed (n 8,500 min 6,600 min Overall length 473 mm 473 mm Net weight 5.5 kg 5.7 kg... -
Page 3: Grinder Safety Warnings
electric shock. before making any adjustments, changing If operating a power tool in a damp location is accessories, or storing power tools. Such unavoidable, use a residual current device preventive safety measures reduce the risk of (RCD) protected supply. Use of an RCD reduces starting the power tool accidentally. - Page 4 The rated speed of the accessory must be at or snagged and your hand or arm may be pulled least equal to the maximum speed marked on into the spinning accessory. the power tool. Accessories running faster than 12. Never lay the power tool down until the their rated speed can break and fly apart.
- Page 5 have a tendency to snag the rotating accessory and d) Do not restart the cutting operation in the cause loss of control or kickback. workpiece. Let the wheel reach full speed and e) Do not attach a saw chain woodcarving blade carefully reenter the cut.
-
Page 6: Functional Description
24. Do not touch the workpiece immediately after FUNCTIONAL DESCRIPTION operation; it may be extremely hot and could burn your skin. 25. Always be sure that the tool is switched off CAUTION: and unplugged or that the battery cartridge is Always be sure that the tool is switched off and •... - Page 7 and then pull the switch trigger (in the B direction). When using an abrasive cut-off / diamond wheel, • Release the switch trigger to stop. be sure to use only the special wheel guard For tool with the lock on and lock-off switch designed for use with cut-off wheels.
-
Page 8: Operation
To remove the wheel, follow the installation procedure in Installing or removing depressed center reverse. grinding wheel/Multi-disc (accessory) Installing or removing abrasive disc (optional 1. Lock nut accessory) 2. Depressed center wheel NOTE: 3. Super flange Use sander accessories specified in this manual. •... - Page 9 or in line with the wire wheel brush. Grinding and sanding operation Do not use wire wheel brush that is damaged, or • ALWAYS hold the tool firmly with one hand on rear which is out of balance. Use of damaged wire handle and the other on the side handle.
-
Page 10: Maintenance
CAUTION: These accessories or attachments are recommended • for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. - Page 11 Side grip Wheel guard for Depressed center grinding wheel/Multi-disc / Wire wheel brush Inner flange / Super flange / Inner flange 102 (Australia and New Zealand only) Depressed center grinding wheel/Multi-disc Lock nut / Ezynut*1 Wheel guard for Abrasive cut off wheel / Diamond wheel Dust collecting wheel guard Inner flange / Super flange / Inner flange 78 (Australia and New Zealand only) Abrasive cut off wheel / Diamond wheel...
- Page 12 Makita Corporation 884635C3...