Makita XLC02 Instruction Manual page 5

completely. Install it fully until the red
indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing
injury to you or someone around you.
Do not use force when installing the
•
battery cartridge. If the cartridge does
not slide in easily, it is not being inserted
correctly.
Battery protection system
(Lithium-ion battery with star
marking)
1
012128
Lithium-ion batteries with a star marking are
equipped with a protection system. This
system automatically cuts off power to the
tool to extend battery life.
The tool will automatically stop during
operation if the tool and/or battery are
placed under
conditions:
Overloaded:
•
The tool is operated in a manner
that causes
abnormally high current.
In this situation, release the trigger
switch on the tool and stop the
application that caused the tool to
become overloaded. Then pull the
trigger switch again to restart.
If the tool does not start, the battery
is overheated. In this situation, let
the battery cool before pulling the
trigger switch again.
Low battery voltage:
•
The remaining battery capacity is
too low and the tool will not operate.
In this
recharge the battery.
1. Star marking
one of the following
it to draw
situation, remove
Switch action
009986
CAUTION:
Before inserting the battery cartridge into the
•
tool, always check to see that the switch
trigger actuates properly and returns to the
"OFF" position when released.
To start the tool, simply pull the switch trigger.
Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched
•
off and the battery cartridge is removed
before carrying out any work on the tool.
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes
•
an
too full, or the suction force weakens.
Be sure to empty out the dust inside the
•
cleaner itself. Failure to do so may
cause the filter to be clogged or the
motor to be damaged.
009992
In order to drop dust sticking on the filter in
and
the capsule, tap the capsule 4 or 5 times
with your hand.
5
1. Switch trigger
1
1. Suction inlet
2. Capsule
2
1