Specifications - Makita BHP442 Instruction Manual

ENGLISH (Original instructions)
1. Red part
2. Button
3. Battery cartridge
4. Switch trigger
5. Lamp
6. Reversing switch lever
7. Speed change lever
8. Action mode changing ring
9. Adjusting ring

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS HAMMER DRIVER
DRILL SAFETY WARNINGS
1. Wear ear protectors with impact drilling. Exposure
to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
Explanation of general view
10. Graduation
11. Arrow
12. Sleeve
13. Bit holder
14. Bit
15. Groove
16. Screw
17. Hook
18. Blow-out bulb
Model
Concrete
Steel
Wood
Wood screw
Machine screw
High (2)
-1
)
Low (1)
High (2)
Low (1)
Net weight
BHP442
6 mm x 75 mm
0 - 1,400
0 - 400
0 - 21,000
0 - 6,000
215 mm
1.8 kg
D.C. 14.4 V
3. Hold power tool by insulated gripping surfaces,
ENE039-1
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
4. Hold power tool by insulated gripping surfaces,
GEA010-1
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
5. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
6. Hold the tool firmly.
7. Keep hands away from rotating parts.
8. Do not leave the tool running. Operate the tool
only when hand-held.
GEB056-4
9. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
10. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
19. Limit mark
20. Rear cover
21. Screws
22. Recessed part
23. Spring
24. Arm
25. Carbon brush cap
26. Hole
13 mm
13 mm
38 mm
M6
BHP452
10 mm x 89 mm
M6
0 - 1,500
0 - 400
0 - 22,500
0 - 6,000
215 mm
1.7 kg
D.C. 18 V
5