Page 1
INSTRUCTION MANUAL Cordless Percussion-Driver Drill BHP442 BHP452 008357 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
The tool is intended for impact drilling in brick, concrete and stone as well as for drilling without impact in wood, metal, ceramic and plastic. For Model BHP442 For European countries only Noise The typical A-weighted noise level determined according...
Director Responsible Manufacturer: Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN Authorized Representative in Europe: Makita International Europe Ltd. Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 8JD, ENGLAND GENERAL SAFETY RULES WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
SPECIFIC SAFETY RULES DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to hammer drill safety rules. If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. SAVE THESE INSTRUCTIONS.
conductive material. Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. Do not expose battery cartridge to water or rain. A battery short can cause a large current flow, overheating, possible burns and even a breakdown.
NOTE: Use a dry cloth to wipe the dirt off the lens of lamp. • Be careful not to scratch the lens of lamp, or it may lower the illumination. Reversing switch action 008349 This tool has a reversing switch to change the direction of rotation.
• battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit or drill bit 008352 Turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Turn the sleeve clockwise to tighten the chuck.
Screwdriving operation 008354 First, turn the action mode changing ring so that the arrow on the tool body points to the the adjusting ring to the proper torque level for your work. Then proceed as follows. Place the point of the driver bit in the screw head and apply pressure to the tool.
Page 9
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. 1. Recessed part Drill bits • 2. Spring Tungsten-carbide tipped hammer bit •...
Page 12
Makita Corporation Anjo, Aichi, Japan 884756-227...