Makita DF030D Technical Information page 4

W
iring diagram
Fig. D-2
Pay attention to the directions of lead wires and connect Flag receptacles
to electrical parts.
Refer to the following illustration.
Terminal
Fig. D-3
Before installing Switch in Housing R, route Lead wires as illustrated below and connect two Connectors.
Do not ride their Lead wires on ribs.
Connector
Fig. D-4
Bend the terminals of DC motor
as illustrated.
Flag receptacles and
Lead wires have to
be far from DC motor.
Do not ride them
on the ribs.
Lead wires holders
red marking
DC motor
Lead wire holders
(To Switch)
Route Lead wires between ribs.
Do not ride Lead wires on their embosses.
Connector
Face the glue-attached portion of LED
to DC motor side.
Lead wires in this area
must be tight.
Insert Connectors between
their Lead wire holders.
P 4/ 4
LED