Advertisement
@ eneeR RoLL LoADING
A new roll of paper should be loaded before first operation or when red paper appears indicating that
the current roll is reaching its end.
*Never attempt operation
without paper. Doing so can damage the printer.
1) Remove the printer cover.
2) When replacing the roll paper, lift up the take up reel and tear the paper between the paper roll and
paper inlet. Press the Fiiill tey to feed the unused paper (Fig. 1), and remove the old paper roll from
the housing.
3) Ensure that paper is being fed from the bottom of the new paper roll (Fig. 2), and set the roll paper
on to the spool in the roll paper housing by pressing outwards on the side of the spool.
4) Squarely iut off the leading end of the paper and insert it into the paper inlet. press the [ETll 6gy
until approximately 20 or 30cm of paper feeds from the printer (Fig. 3).
..ji:,:. iS-
(Fis. 2)
JOURNAL
5) Remove the flat flange from the take up reel by sliding the end of the spindle into the large hole
provided in the flange (Fig, 4).
6) When replacing the roll paper, slide the printed journal paper roll from the take up reel.
7) Clip the leading end of the paper onto the take up reel as illustrated, and wind the paper two or
three turns onto the reel (Fig. 5).
8) Replace the flange on the take up reel and ensure that it snaps firmly back into place.
9) Replace the take up reel into the ECR, and the printer cover.
RECEIPT
5) Fbss the leading end of the paper through the paper outlet slot in the printer cover and replace the
printer cover (Fig. 6).
6) Tear off the excess receipt paper.
\
(Fis. 5)
ttx
'e
( F i s . 6 )
!
{
"lfl..
{&
I
I
:
t
(Fis. 1)
(Fis. 4)
- 6 -
Advertisement
