Panasonic KX-TD500 System Reference Manual page 1324

• Storing a dialing name
Operation
To enter into the programming
mode
1. Set the MEMORY switch at
the rear of the PITS to
PROGRAM.
SET• • PROGRAM
MEMORY
• With DPITS, press the
PROGRAM button.
2. Press one of the function
keys to program.
PROGRAM
Soft 1 Soft 2 Soft 3
3. Press the NEXT (S3) button.
The display is changed to
enter the name.
CLR NEXT
PROGRAM
Soft 1 Soft 2 Soft 3
4. Enter the name.
<Example>
When entering "Ann".
a) Press the dial 2.
Result
• The following message
appears on the display:
PITS-PGM No.?
• The MEMORY button indicator
lights red.
• If a phone number has already
been stored in memory, the
number is displayed.
If not, "Not Stored" is displayed.
1234567
SHIFT
CLR NEXT
PROGRAM
Soft 1 Soft 2
• If a dialing number has already
been stored in memory, the
name is displayed.
Anne
SHIFT PROGRAM
Soft 1 Soft 2
a) "A","B" or "C" can be entered.
A
PROGRAM
Soft 1 Soft 2
13-C-12
• This status is called "Initial
display for PITS station
programming mode".
• If the programming data of your
PITS has already been
accessed by another
administration device, the
following message appears on
the display.
Already Accessed
• If the END button is pressed
while programming, the above
message appears on the
display again.
SHIFT
Soft 3
SHIFT
Soft 3
2
B C
SHIFT
Soft 3
Comment/Note
Continued