Panasonic KX-TD500 System Reference Manual page 1129

Item
Assigning Items
Number
Conditions
If "SLA" command is entered without index number, all physical slot numbers will be
displayed in ascending order (from 101 to 314).
Card assignment and the status
• See Section 1-A-5.00 "Service Cards Description" for cards description.
• See Section 10-C-2.00 "Slot Assignment" for installing the cards in combination.
• When assigning a card, the card status is Out of Service (OUS). When using the
card, the card status should be set to In Service (INS).
For In Service (INS) and Out of Sevice (OUS), refer to Section 9-F-3.00 "In
Service (INS)" and Section 9-F-4.00 "Out of Service (OUS)".
For confirming whether card status is INS or OUS, refer to Section 16-F-1.02
"Card Status Screen".
• T-1 and E-1 cards can only be assigned to the odd slot number in each shelf.
• When T-1 or E-1 card is assigned, "***" is displayed on the next slot number and
any assignment is impossible.
Relations between this assignment and the other assignments
• If no CO trunk card is assigned, it is not possible to program "CO Line (COL)".
• If AGC card is not assigned, "Automatic Gain Control (AGC)" cannot be pro-
grammed.
• If DPH card is not assigned, "Doorphone (DPH)" cannot be programmed.
• If ATLC card is not assigned, it is not possible to program "Attendant Console
(ATT)" and "Attendant Queue Priority (AQP)".
• If DISA card is not assigned, it is not possible to program "DISA (DIS)", "DISA
Code (DIC)" and "DISA Password (DIP)".
• If DID card is not assigned, it is not possible to program "DID (DID)".
When deleting or changing the card assignment
• When deleting or changing the pre-assigned card type, the conditions should be
the followings:
— The card status is OUS or Fault.
— All of the port data has been deleted.
However, if there exist port data, it is possible to change the cards as follows:
— PLC card
— SLC card
14 : T-1 (T-1 Trunk) card
15 : E-1 (E-1 Trunk) card
16 : AGC (Automatic Gain Control) card
17 : DISA (Direct Inward System Access) card
18 : OPX (Off Premise Extension) card
19 : ATLC (Attendant Console Line Circuit) card
20 : DPH (Doorphone Circuit) card
21 : RMT (Remote Circuit) card
HLC card
HLC card
Input Value
11-C-3
Continued