Honeywell Prestige THX9321 System Installation Manual page 5

THX9321/942f Prestige
_ IAQ and RF ElM
O Link thermostat to the wireless network
(if used with an ElM or TrueZONE Wireless Adapter)
Next, link all components and RedLINK 'Maccessories to the wireless network.
|nitiai powerup configuration
When the thermostat is first activated, it wilt lead you through the steps
necessary to define and set up your system. The steps will change depending on
the type of system and thermostat you're installing.
Setup options for THX9321 Setup options for THX9421
If non-zoned system: If non-zoned system:
* Setup for thermostat only * Setup for ElM connection
, Setup for use with ElM
If zoned system:
* Setup for ElM wired to zone panel
, Setup br thermostat wired to zone panel
, Setup for RedLINK wireless connectionto zone panel
(using THM400OTrueZONEWireless Adapter)
If zoned system:
• Setup br ElM wired to zone panel
• Setup for RedLINK wireless connectionto zone panel
(using THM400OTrueZONEWireless Adapter)
Link thermostat to ElM or TrueZONE _ Wireless Adapter
Use the step-by=step thermostat menus to define your system type (above).
When you reach the Wireless Setup screen, follow the steps below:
M_;R32941
"Connected" status light
• Green flashing: In Wireless Setup mode.
• Green steady: System is working normally,
o
Press and releasethe CONNECTbutton at the ElM or Wireless
Adapter,and make surethe "Connected"light is flashinggreen.
If the "Connected"light does not flash, makesure no other
RedLINK devices are inWireless Setup mode,then try again.
If the "Connected"light does not flash on the Wireless
Adapter,consult the TrueZONEmanualfor help.
Red: Wireless device(s) not communicating.Check ElM and RedLINK devices.
While the ElM light is flashing, press NEXTto link
the thermostatwith the ElM. Aftera brief delay,
the screenwill display"DeviceConnected."
At any screenyou can press HELPfor moreinformation,
or pressBACKto change earlieroptions.
5 69-2490--03