Makita 6503D Instruction Manual page 11

ASSEMBLY
Installing or removing drill bit
CAUTIO N :
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as
it
will go. Hold
the ring firmly and turn the sleeve clock-
wise to tighten the chuck.
To remove the bit, hold the ring and turn
the sleeve counterclockwise.
Adjusting depth of drilling
Install the depth gauge on the tool with the
clamp screw and washer. Adjust the depth
gauge to the desired depth and tighten the
clamp screw.
Installing set plate (optional accessory)
Always install the set plate when using bat-
tery cartridges 9100, 9102, 9102A. Install
the set plate on the tool with the screw
provided.
Depth'gauge
/
Clamp screw
Screw
Set plate
11