Makita VC3211M Instruction Manual page 7

Locking or unlocking the caster
3
1
4
2
013482
To lock the caster with a stopper, lower the stopper lever
and the caster no longer will rotate. To release the
caster from the locked position, raise the stopper lever.
Locking the caster is convenient when storing the
cleaner, stopping the work on the way and keeping the
cleaner still.
To operate the stopper, move it by hand.
NOTICE:
When moving the cleaner, make sure that the
•
caster is unlocked. Moving the cleaner with the
caster in the locked position may cause damage to
the caster.
Cap
There is a cap on the mounting port. The cap prevents
the vacuumed dust from getting out from the cleaner.
ASSEMBLY
WARNING:
This unit may contain hazardous dust. When
•
replacing filter elements and dust bag, always use
a P2-respirator.
Always be sure that the cleaner is switched off and
•
unplugged before carrying out any work on the
cleaner.
Never switch on until all filters and dust bag are
•
completely installed and the volume flow control is
tested.
Installing and disposing the filter bag
WARNING:
Always use a P2-respirator.
•
When using the filter bag, also use the air filter
•
together that is preinstalled on the tool. Failure to
use the air filter together may cause unusual noise
and heat, resulting in a fire.
CAUTION:
Never pick up water or other liquids or wet dusts
•
when using the filter bag. Picking up such things
may cause the filter bag breakage.
1. FREE position
2. LOCK position
3. Stopper lever
4. Caster
7
013377
1. Extend the filter bag.
013378
2. Align the filter bag opening with the dust suction
opening of the cleaner.
3. Insert the cardboard of the filter bag onto the tool
so that it is positioned at the end beyond the
detent protrusion.
When disposing the filter bag, pull the edge on the filter
bag's mouth so that the mouth is closed by a paper.
Installing polyethylene bag
Cleaner can also be used without polyethylene bag.
However, using polyethylene bag is easier to empty the
tank without letting your hands dirty.
1
3
013383
Spread the polyethylene bag in the tank. Insert it between
the holder plate and the tank, and pull it to the hose inlet.
1
2
013384
Spread the bag around the top of the tank.
1. Filter bag
1
1. Filter bag
1
1. Holder plate
2. Polyethylene
bag
2
3. Tank
1. Holder plate
2. Polyethylene
bag