Replacement Filter Assembly - RIDGID WD1851 Operator's Manual

SP6673-1 ES 0108.qxd 1/24/08
Replacement Filter Assembly (continued)
! WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac
with any parts damaged or missing.
3. Place the float over the opening in the
center of the lid with the words "This
Side Towards Lid" laying face down
over the hole.
WARNING: To avoid personal
!
injury or damage to vac be sure to
keep hands, fingers, or any other
foreign objects out of the center
opening when assembling the float.
4. Line up filter cage tabs with slots in the
center ring of the lid.
5. Push on the filter cage until the tabs
snap into slots for a secure fit.
Drum/Caddy Assembly
If any parts are missing or damaged
contact Customer Service.
Do not assemble until you have all the
parts.
1. Insert caddy left and caddy right into
the bottom of drum as shown. Light
taps with a mallet or hammer may be
needed to fully seat both caddies.
2. Install (4) #10 x 1-3/4" screws into
matching holes on both right and left
side of caddy, securing them to the
bottom of the drum. Tighten screws
until just snug. Do not over tighten as
this may tend to deform the caddies.
1:52 PM Page 6
Filter Cage
Tabs (3)
Float
Solid End
THIS SIDE
TOWARD LID
Drain
#10 x 1-3/4"
Screw (4)
6
Power Head
Assembly
Slots (3)
Filter Cage
Tabs (3)
Slots (3)
Caddy
Right
Caddy
Left
Left Caddy
Assembly
Drain
Right
Caddy
Assembly