When you stop the operation of a CPU module, the indications of the status LEDs change as
follows. Below denotes that the only one CPU module is operating.
[Indications of status LEDs]
1
CPU/IO module status LED1
2
CPU/IO module status LED2
3
DISK ACCESS LED
As an example, the indications of when CPU module 0 is stopped are shown.
3.
Press the start button of the CPU module stopped by ft server utility.
In the ft server utility, select the stopped CPU module and click [Up] of [Bring Up/Bring
Down].
Once the CPU module is started, hardware diagnosis and then synchronization of memory
(memory copy) are performed, and the duplication process is completed.
Note that the system is paused temporarily for copying memory during memory
synchronization.
[Indications of status LEDs during diagnosis]
1
CPU/IO module status LED1
2
CPU/IO module status LED2
3
DISK ACCESS LED
[Indications of status LEDs after completion of duplication]
1
CPU/IO module status LED1
2
CPU/IO module status LED2
3
DISK ACCESS LED
IMPORTANT:
After duplication is completed, the status of memory will be checked.
Wait until this process ends to perform the next step (evaluation of start and stop of PCI
and CPU modules). When the process is complete, the following event log will be
output:
Source:
Type:
Event ID:
Description: Memory consistency check has completed memory scan.
LED
LED
LED
srabid
Information
4137
Windows Setup and Operation 3-37
CPU module 1
(Stopped)*
Amber
-
Green blinking
CPU module 0
(Started)
-
-
Green blinking
CPU module 0
(Operating)
-
Green
Green blinking
CPU module 2
(Operating)
-
Green blinking
Green blinking
CPU module 1
(Operating)
-
Green blinking
Green blinking
CPU module 1
(Operating)
-
Green
Green blinking