Panasonic KX-TDA100 Features Manual page 406

4.7 Configuration [1]
Programming Guide References
4.7.20 PRI Port [1-6] Port Command
Feature Guide References
None
Subscriber Number
Specifies the number used as the CLIP number.
Default
Not stored.
Value Range
Max. 16 digits (consisting of 0–9, *, and #)
Programming Guide References
None
Feature Guide References
1.19.1.2 Calling Line Identification Presentation (CLIP)
Sending Ring Back Tone to Network
Enables the PBX to send a ringback tone to the caller when there is no ringback tone sent from the network.
Default
Enable
Value Range
Disable, Enable
Feature Guide References
None
ISDN In / Out Call Type
Selects the method used to send dialed digits to the network.
Default
CO port: En-bloc
QSIG (slave/master) port: Overlap
Value Range
En-bloc: The PBX sends all of dialed digits at once after the extension user completes dialing. The PBX
recognizes the end of dialing when (1) # is dialed, if programmed, (2) programmed telephone number is
dialed, or (3) the inter-digit timer expires.
Overlap: The PBX sends dialed digits one at a time.
406 Feature Guide