Huawei SmartDC V100R021C10 User Manual page 385

ECC800 Data Center Controller
User Manual
Parameter
Communications
address
Step 2 Add the device to the ECC800-Pro WebUI.
1.
2.
3.
----End
Follow-up Procedure
Choose Home > Plan View on the ECC800-Pro WebUI, and drag the device to the
corresponding position in the Smart Module View pane based on the actual
device layout.
Issue 04 (2021-10-09)
Log in to the ECC800-Pro WebUI as an administrator.
Add the device.
Table 8-46 Parameter description for adding a device
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device. The
parameters
for adding
Communicati
devices are
ons Port
displayed.
Device
Address
Click Test Connect to check whether the device connects to the ECC800-Pro
properly.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
Copyright © Huawei Technologies Co., Ltd.
Recommended Value
This section uses 1 as an example. Set this parameter
based on site requirements.
Setting
Select the device attribute to be accessed
from the drop-down list box.
Select the device type to be accessed from
the drop-down list box.
Select ECC800 from the drop-down list
box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the device
connects to the COM1 port on the ECC800-Pro.
If the device connects to another port, enter the
number of the connected port.
This section uses 1 as an example. In
practice, set this parameter to be the same
as the communications address for the
device.
8 FAQ
373