Siemens SINUMERIK 840D sl Series Diagnostics Manual page 556

Overview of Alarms
Parameters: %1 = File name
Definitions: In the start-up area the softkey "delete boot files", for example, was pressed, although no
boot files are yet available.
Remedy: --
101158
Function in current operating mode not allowed
Definitions: The drive's current status does not permit this function.
Remedy: --
101159
Remote block in incorrect state
Definitions: The drive's current status does not permit this function.
Remedy: --
101160
Date and time of PLC set
Definitions: In the PLC status, the time or date was changed.
Remedy: --
101161
The drive is not in cyclic mode!
Definitions: The start-up is not completely carried out, therefore, the function "Calculate motor data"
cannot be selected.
Remedy: --
101162
MDx134/MDx400 MOTOR_NOMINAL_FREQUENCY/MOTOR_RATED_SPEED illeg.
Definitions: --
Remedy: --
101163
MDx130 MOTOR_NOMINAL_POWER <= 0
Definitions: --
Remedy: --
101164
MDx132 MOTOR_NOMINAL_VOLTAGE <= 0
Definitions: --
Remedy: --
101165
MDx103 MOTOR_NOMINAL_CURRENT <= 0
Definitions: --
Remedy: --
101166
MDx129 POWER_FACTOR_COS_PHI illegal
Definitions: --
Remedy: --
101167
MDx134/MDx400 MOTOR_NOMINAL_FREQUENCY/MOTOR_RATED_SPEED illeg.
Definitions: --
Remedy: --
101168
Warning MDx142 FIELD_WEAKENING_SPEED<MDx400 MOTOR_RATED_SPEED
Definitions: --
Remedy: --
101169
Date and time could not be set!
2-556
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005