Siemens SINUMERIK 840D sl Series Diagnostics Manual page 477

08/2005
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: First execute a manual tool change, then restart the block search.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61284
Channel %1 block %2: starting point cannot be approached without collision. Pre-
position tool manually
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The starting point cannot be approached without collisions.
Alarm triggered by following cycles: F_DRILL, F_DRILLC, F_DRILLD, F_DRM_DR,
F_DRM_PE, F_DRM_RE, F_DRM_SI, F_DRM_TA, F_GROOV, F_MIM_TR,
F_PARTOF, F_SP_EF, F_TAP, F_TR_CON, F_UCUT_T.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Preposition the tool manually.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61285
Channel %1 block %2: parking position is below return plane XRA.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parking position is below retraction plane XRA.
Alarm triggered by following cycle: F_SP_RP.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Move the parking position above retraction plane XRA.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61286
Channel %1 block %2: machining not possible, check tool angle.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Machining not possible with the specified tool.
Alarm triggered by following cycles: F_UCUT_T.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Use a suitable tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61287
Channel %1 block %2: no master spindle active.
Parameters: %1 = Channel number
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-477