Siemens SINUMERIK 840D sl Series Diagnostics Manual page 504

Overview of Alarms
Definitions: G40 was inactive before the cycle call.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61816
Channel %1 Block %2: Axes not on reference point
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reactions: - Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61817
Channel %1 Block %2: Axis coordinates within protection zone
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reactions: - Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61818
Channel %1 Block %2: Axis range limits are equal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reactions: - Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61900
Channel %1 block %2: No contour available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61901
Channel %1 block %2: Contour not closed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61902
Channel %1 block %2: No more memory available
Parameters: %1 = Channel number
2-504
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005