Table of Contents
Advertisement
8.5.3.2
Control data record
Operating principle
You define a control data record 196 V1.0, which includes a slot assignment for the
configuration control of an HSC. The control data record can also be read back.
The control data record is only processed with configured configuration control; otherwise it
is rejected.
Rules
Observe the following rules:
● The entry for slot 1 only identifies the PM (see also Table 8-1 Slot assignment (Page 94)).
● All modules up to the maximum possible configuration of the HCS must be registered in
control data record.
● The entries up to at least the last slot of the station master must be contained in the
control data record. Entries beyond the last slot must be pre-assigned with "Module not
available".
● Multiple configured slots must not be assigned to the same actual slot. In other words,
each station option slot can be present only once in the control data record.
● Gaps are not permitted.
● Moving modules is not allowed.
SIPLUS HCS4300 PROFINET/PROFIBUS DP
Operating Instructions, 10/2019, A5E35452705A/005
Configuring/Programming
8.5 Configuration control
95
Advertisement
Table of Contents
