Specify Wear And Setup Values ($Tc_Scpxy[T,D], $Tc_Ecpxy[T,D]) - Siemens SINUMERIK 840DE Programming Manual

Fine offset:
Location-dependent allowances can be made for over/under-dimensioning.
Parameters
Machine data are used to activate and define the number of additive offsets. Please refer to
the machine manufacturer's instructions.
Example
N110 T7 D7
N120 G0 X10 Z1
N130 G1 Z-6
N140 G0 DL=2 Z-14
N150 G1 Z-21
N160 G0 X200 Z200
...
8.16.2

Specify wear and setup values ($TC_SCPxy[t,d], $TC_ECPxy[t,d])

Function
Wear and setup values can be read and written via system variables and the corresponding
OPI services.
The logic is based on the logic of the corresponding system variables for tools and tool
edges.
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Location 2 Location 1
;The tool turret is positioned at location 7
;D7 and DL=1 are activated and traversed in the
next block
;N120
;DL=2 is activated in addition to D7 and traversed
;in the next block
;Approach tool change point
Tool offsets
8.16 Additive offsets
8-69