Siemens SINUMERIK 840D sl Operating Manual page 233
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
The tool creation sequence can be defined differently.
Unloading a tool in a file
According to the corresponding setting, the unloaded tool is deleted from the NC memory after
it has been read out.
Deleting a tool in a file
Universal
Operating Manual, 05/2017, A5E40868517
5.
Navigate to the required file and press the "OK" softkey.
The tool data is read from the file, and is displayed in the "New Tool from
File" window with the tool type, tool name and possibly with certain pa‐
rameters.
6.
Press the "OK" softkey.
The tool is added to the tool list with the specified name. If the cursor is
located on an empty magazine location in the tool list, then the tool is
loaded to this magazine location.
1.
The tool list is open.
2.
Place the cursor on the tool that you would like to unload from the mag‐
azine and press the "Unload" and "In file" softkeys.
3.
Navigate to the required directory and press the "OK" softkey.
4.
Enter the required file name in the "Name" field and press the "OK" soft‐
key.
The field is preassigned with tool names.
The tool is unloaded and the tool data is written to the file.
1.
The tool list is open.
2.
Position the cursor on the tool that you wish to delete.
3.
Press the "Delete tool" and "In file" softkeys.
3.
Navigate to the required directory and press the "OK" softkey.
4.
Enter the required file name in the "Name" field and press the "OK" soft‐
key.
The field is preassigned with tool names.
The tool is unloaded and the tool data is written to the file. The tool is then
deleted from the NC memory.
Tool management
11.5 Tool list
233
Advertisement
Table of Contents
