Continuing Program From Search Target - Siemens SINUMERIK 840D sl Operating Manual

Preconditions
● You have selected the desired program.
● The controller is in the reset state.
● The desired search mode is selected.
Toggling between search pointer and search positions
See also
Block search mode (Page 113)
Selecting a program (Page 100)
6.7.2

Continuing program from search target

To continue the program at the desired position, press the <CYCLE START> key twice.
● The first CYCLE START outputs the auxiliary functions collected during the search. The
program is then in the Stop state.
● Before the second CYCLE START, you can use the "Overstore" function to create states
that are required, but not yet available, for the further program execution.
By changing to the JOG REPOS mode, you can also manually traverse the tool from the
current position to the setpoint position, if the setpoint position is not to be automatically
approached after the program start
Universal
Operating Manual, 05/2017, A5E40868517
NOTICE
Risk of collision
Pay attention to a collision-free start position and appropriate active tools and other
technological values.
If necessary, manually approach a collision-free start position. Select the target block
considering the selected block search type.
Press the "Search pointer" softkey again to exit the "Search Pointer" win‐
dow and return to the "Program" window to define search positions.
- OR -
Press the "Back" softkey.
You have now exited the block search function.
Machining the workpiece
6.7 Starting execution at a specific point
109