Cutting Edge Data - Siemens SINUMERIK 840D sl Operating Manual

Tool management
13.9 Tool details
Parameter
Tool size
Tool OEM parameters
1 - 6
13.9.3

Cutting edge data

The "Tool Details" window provides the following data on the selected tool when the "Cutting
edge data" softkey is active.
Parameter
Magazine location
Tool name
ST
D quantity
D
Tool type
Geometry
Wear
Geometry
Wear
Type 240 - tap
Pitch
Type 200 - twist drill, type 220 - centering tool and Type 230 - countersink
Tip angle
Type 520 -plunge cutter, type 530 - parting tool, type 540 - threading tool
662
Meaning
P Tool in fixed location
The tool is permanently assigned to this magazine location
I Tool has been in use
Standard Tool does not require an additional location in a magazine.
Oversize The tool occupies two half locations left, two half locations right, one half
location top and one half location bottom in a magazine.
Special size
Left Number of half locations to the left of the tool
Right Number of half locations to the right of the tool
Freely available pa‐
rameters
Meaning
The magazine number is specified first, followed by the location num‐
ber in the magazine.
If there is only one magazine, only the location number is displayed.
The tool is identified by the name and the sister tool number. You
can enter the name as text or number.
Sister tool number (for sister tool strategy)
Number of created cutting edges
Cutting edge number
Tool symbol with type number
Length
Tool length
Tool wear
Ø (diameter)
Tool diameter
Tool wear, diameter
Height of the developed helix parallel to the screw axis
Angle is less than 180°
Operating Manual, 05/2017, A5E40868956
Milling