Toshiba Q9 Installation And Operation Manual page 158

F721
Panel Stop Pattern
Program  Panel Control
While operating in the Local mode this parameter determines the method used to
stop the motor when the stop command is issued via the EOI.
The Decel Stop setting enables the Dynamic Braking system that is setup at
F304 or the DC Injection Braking system that is setup at F250, F251, and F252.
The Coast Stop setting allows the motor to stop at the rate allowed by the inertia
of the load.
Settings:
0 — Deceleration Stop (Not Used)
1 — Coast Stop
Note: The Stop Pattern setting has no effect on the Emergency Off
settings of F603. This parameter may also be accessed by pressing
the ESC key from the Frequency Command screen.
Panel Frequency Lockout
Program  Utility Group
While operating using the LED Keypad Option this parameter Enables/Disables
the ability to change the frequency command value.
Note: The LED keypad is unavailable at the time of this release.
Settings:
0 — Unlocked
1 — Locked
Panel Emergency Off Lockout
No Path — Direct Access Only
While operating using the LED Keypad Option this parameter Enables/Disables
the ability to provide an Emergency Off command.
Settings:
0 — Unlocked
1 — Locked
Panel Reset Lockout
No Path — Direct Access Only
While operating using the LED Keypad Option this parameter Enables/Disables
the ability to initiate a Reset.
Settings:
0 — Unlocked
1 — Locked
148
Direct Access Number — F721
Parameter Type — Selection List
Factory Default — Deceleration Stop
Changeable During Run — Yes
Direct Access Number — F730
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — Yes
Direct Access Number — F734
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — No
Direct Access Number — F735
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — Yes
Q9 ASD Installation and Operation Manual
F735