Toshiba Q9 Installation And Operation Manual page 157

F703
User Unit Type
Program  Utility Group
This parameter is used in conjunction with
frequency is displayed on the front panel.
The multiplier setting of F702
All Frequencies are selected at this parameter.
The multiplier setting of F702
and F368 ONLY if PID Process Data is selected at this parameter.
Settings:
0 — All Frequencies
1 — PID Process Data
Display Bias
No Path — Direct Access Only
In conjunction with the setting of F702, this parameter sets the bias of the front
panel speed display.
The frequency entered here will be multiplied by the setting of
displayed as the zero value on the front panel display.
Change Step Selection 1
No Path — Direct Access Only
In conjunction with the parameter setting of F708, this parameter sets the amount
that the output speed will increase or decrease for each speed command change
entered from the front panel using the Rotary Encoder.
Change Step Selection 2
No Path — Direct Access Only
The parameter is used to modify the degree that the setting of
output speed changes that are input from the front panel using the Rotary
Encoder.
Selecting a zero value here disables this parameter and the resulting non-zero
value of parameter setting
Selecting a non-zero value here provides a dividend that will be used in the
following equation resulting in the actual output frequency applied to the motor.
Outpu tFrequ enc yDisplay ed
Q9 ASD Installation and Operation Manual
F702 to set the method in which the
will be applied to the display of all frequencies if
will be applied to parameters F364, F365, F367,
F707 is output from the ASD.
= In te rna lly Command edFreque ncy
Direct Access Number — F703
Parameter Type — Selection List
Factory Default — All Frequencies
Changeable During Run — Yes
Direct Access Number — F706
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
F702 and then
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F707
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F708
Parameter Type — Numerical
Factory Default — 0 (Disabled)
F707 affects the
Changeable During Run — Yes
Minimum — 0
Maximum — 255
F708
×
------------ -
F707
F708
147