Wireless System Messages - Bosch ICP-EZM2 Installer's Manual

Easy Series (ICP-EZM2) | Installer Guide | 3.0 Point Expansion
3.3

Wireless System Messages

Refer to the following table for a description of system messages that pertain to the wireless network.
System Message
"Wireless devices not configured."
"Extra device ignored."
"Point x was tested."
"Point x low."
"Please wait."
"Wireless error."
"Wireless devices x."
"Wireless devices not tested x."
"Point x not tested."
28
Description
Point Test was exited before all wireless points were tested.
An attempt was made to add a device to a system that already contains
the maximum number of points or outputs.
A point was tested. RFSS is acceptable.
A point was tested. RFSS is unacceptable.
The wireless network is busy, or the control panel is waiting for the
wireless network to respond.
The control center might show a single rotating segment of the circle of
protection with this message.
The wireless hub is jammed, missing, or experiencing a trouble
condition.
"x" = the number of devices that are discovered, but not tested.
"x" = the number of devices that are discovered, but not yet configured.
The control panel assigned a point number to the device, but the device
was not tested (faulted, or tampered, and restored).
"x" = the voice description.
By default, the system announces the point number.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01