Motorola Netopia 2200 Series User Manual page 225

CONFIG Commands
Static ARP Settings
Your Motorola Netopia® Gateway maintains a dynamic Address Resolution Protocol (ARP)
table to map IP addresses to Ethernet (MAC) addresses. Your Motorola Netopia® Gateway
populates this ARP table dynamically, by retrieving IP address/MAC address pairs only
when it needs them. Optionally, you can define static ARP entries to map IP addresses to
their corresponding Ethernet MAC addresses. Unlike dynamic ARP table entries, static ARP
table entries do not time out.
You can configure as many as 16 static ARP table entries for a Motorola Netopia® Gate-
way. Use the following commands to add static ARP entries to the Motorola Netopia®
Gateway static ARP table:
set ip static-arp
ip-address
Specifies the IP address for the static ARP entry. Enter an IP address in the ip_address
argument in dotted decimal format. The ip_address argument cannot be 0.0.0.0.
set ip static-arp
ip-address
MAC_address
Specifies the Ethernet hardware address for the static ARP entry. Enter an Ethernet hard-
ware address in the MAC_address argument in
mat.
IGMP Forwarding
set ip igmp-forwarding [ off | on ]
Turns IP IGMP forwarding off or on. The default is off.
IPsec Passthrough
set ip ipsec-passthrough [ off | on ]
Turns IPsec client passthrough off or on. The default is on.
ip_address
ip_address
hardware-address
nn.nn.nn.nn.nn.nn
(hexadecimal) for-
225