Motorola Netopia 2200 Series User Manual page 195

CONFIG Commands
set atm [vcc n ] qos sustained-cell-rate { 1 ... n }
If QoS class is set to vbr, then specify the sustained-cell-rate that should apply to the
specified virtual circuit. This value should be less than, or equal to the Peak Cell Rate,
which should be less than, or equal to the line rate.
set atm [vcc n ] qos max-burst-size { 1 ... n }
If QoS class is set to vbr then specify the max-burst-size that should apply to the speci-
fied virtual circuit. This value is the maximum number of cells that can be transmitted at
the Peak Cell Rate after which the ATM VC transmission rate must drop to the Sustained
Cell Rate.
set atm [vcc n ] vpi { 0 ... 255 }
Select the virtual path identifier (vpi) for VCC n.
Your Service Provider will indicate the required vpi number.
set atm [vcc n ] vci { 0 ... 65535 }
Select the virtual channel identifier (vci) for VCC n. Your Service Provider will indicate the
required vci number.
set atm [vccn] encap { ppp-vcmux | ppp-llc | ether-llc |
Select the encapsulation mode for VCC n. The options are:
ppp-vcmux
ppp-llc
ether-llc
ip-llc
pppoe-vcmux
pppoe-llc
Your Service Provider will indicate the required encapsulation mode.
ip-llc | ppoe-vcmux | pppoe-llc }
PPP over ATM, VC-muxed
PPP over ATM, LLC-SNAP
RFC-1483, bridged Ethernet, LLC-SNAP
RFC-1483, routed IP, LLC-SNAP
PPP over Ethernet, VC-muxed
PPP over Ethernet, LLC-SNAP
195