Config Commands - Motorola Netopia 2200 Series User Manual

CONFIG Commands

CONFIG Commands
This section describes the keywords and arguments for the various CONFIG commands.
Remote ATA Configuration Commands
Motorola Netopia® firmware supports configuration of a maximum of four Motorola Neto-
pia® ATA profiles, which are stored in the Gateway's configuration database. When a
Motorola Netopia® ATA is discovered, the Gateway compares the MAC address of the ATA
with one of the existing profiles stored in the database. If there is a match, the configura-
tion is downloaded to the Motorola Netopia® ATA, and the ATA is restarted. Once the
Motorola Netopia® ATA is restarted, it comes up with the newly downloaded configuration.
set ata profile [ 0... 3 ] ata-option [ on | off ]
Enables or disables the remote ATA configuration option for the specified ATA configuration
profile to be stored in the Gateway.
set ata profile [ 0... 3 ] ata-mac-addr MAC_addr
Specifies the MAC address of the ATA for the specified configuration profile.
set ata profile [ 0... 3 ] ata-qos-enable [ on | off ]
Enables or disables QoS for the specified profile.
set ata profile [ 0... 3 ] ata-dhcpc-enable [ on | off ]
Enables or disables DHCP client service for the specified profile.
set ata profile [ 0... 3 ] ata-dhcpc-hostname string
Specifies a DHCP client hostname for the specified profile.
set ata profile [ 0... 3 ] ata-dhcpc-vid-enable [ off | on ]
Enables or disables a DHCP client vendor ID for the specified profile.
191