Motorola Netopia 2200 Series User Manual page 176

reset heartbeat
Restarts the heartbeat sequence.
reset ipmap
Clears the IPMap table (NAT).
reset log
Rewinds the diagnostic log display to the top of the existing Motorola Netopia® Gateway
reset show
diagnostic log. The log command does not clear the diagnostic log. The next
log command will display information from the beginning of the log file.
reset security-log
Clears the security monitoring log to make room to capture new entries.
reset wan-users [all | ip-address ]
This function disconnects the specified WAN User to allow for other users to access the
WAN. This function is only available if the number of WAN Users is restricted and NAT is on.
Use the all parameter to disconnect all users. If you logon as Admin you can disconnect
any or all users. If you logon as User, you can only disconnect yourself.
reset wan
This function resets WAN interface statistics.
reset wepkeys
This function allows you to force your wireless WEP key settings back to the default values,
if there are default values. For example, on some models, the WEP keys are based on the
serial number. This allows you to get back those default settings if you have changed them
without the need to reset the entire configuration of the unit.
176