Using System Functions From An External Location (Disa - Direct Inward System Access) - Siemens HiPath 2000 Operating Manual

Additional Features/Services
Step by Step
96
Using System Functions from an
External Location (DISA - Direct In-
ward System Access)
If this function has been configured (contact your ser-
vice personnel), you can set up external outgoing calls
from outside the system, as if you were an internal
user. You can also activate and deactivate the following
functions in your system:
• Reset services and functions,
code #0
• Call forwarding, code:
• Locking and unlocking telephone,
code
*
• Save PIN,
code:
*
• Send a message,
code:
*
• Leave an advisory message,
code
*
• Group ringing, code:
• Group call, code:
• Suppress call ID,
code:
*
• Waiting tone, code:
• Open door, code:
• Door opener on/off, code:
• Control relay, code
• Do not disturb, code:
• Ringer cutoff function, code:
• Speed-dialing, code:
• Associated service, code:
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
~
Set up a call to the system. Enter the station number
(contact your service personnel).
Ö ~
Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
#
Enter the code (necessary only if programmed in the
system).
Page 94
1/#1
*
66/#66 Page 87
93 Page 89
68/#68 Page 90
69/#69 Page 91
81/#81
*
85/#85
*
86/#86 Page 84
87/#87
*
61 Page 44
*
90/#90
*
97/#97
*
7
*
Page 32
Page 103
Page 103
Page 60
89/#89 Page 45
*
Page 101
Page 83
98/#98 Page 83
*
Page 49
83 Page 95
*