Line When - Panasonic KX-T336 System Reference Manual

4.00 Automatic Line Hunting
(Calling) Selection
This feature automatically connects a PITS
telephone to a pre-assigned line when an
extension user lifts the handset or press the SP-
PHONE to make calls.
There are two options by which an extension user
may select a desired line:
l
Prime Line Preference-Calling (Default)
'0 Idle Line Preference-Calling
If "No Line Preference-Calling" is selected, no line is
connected to a PITS telephone by lifting the handset
or pressing the SP-PHONE button.
For further information about this feature, refer to
Section 4-C-l .OO 'Line Selection-Calling."
The table shows the operation for each programming.
(The explanation of the message display applies only
to a PITS provided with the display.)
Operation
Result
Comment/Note
1. Set the MEMORY switch at
l
The following message
l
This status is called 'Initial
the rear of PITS to
appears on the display:
display for PITS-station
"PROGRAM." programming mode."
PITS-PGM No.?+
l
If the following message
appears on the display, the
SET-.PROWWd
l
The MEMORY button indicator
programming data of your
lights in red. PITS has already been
accessed by another
administration device:
Already Accessed
2. Dial '00."
l
Preset data appears on the
l
From now on in any status,
pressing the END button
restores this status.
. .
l
If nothing is entered within one
minute after dialing "00,"
"Initial display for PITS-
station programming mode" is
shown again on the display.
Pref. Out : No.
I
.+A+;.'
- : b.
l
The MEMORY button indicator
light goes out.
3. To change the preset
feature, dial the appropriate
program number
corresponding to the desired
feature.
l
To change the assignment,
simply dial the appropriate
number again.
l
To set "No Line Preference,"
l
The following message
dial "1." appears on the display:
•l
1
Pref. Out : No.
1
12-C-l 5
Continued