Panasonic KX-T336 System Reference Manual page 197

Description of Assigning Items
Trunk Group
Assigns the trunk group number of the CO line.
Trunk Name Assigns the name of the CO line. This will appear on the CRT screen of
the Attendant Console and the display of PITS telephone (if provided)
when making oi receiving a CO call.
Direct Termination Assigns the directory ntimber of the destination, when the trunk group of
the line is set to "DIL 1 :l" in Incoming Mode (Day).
Night Answer Point
(Type : No.)
Assigns Night Answer point when the "Incoming Mode (Night)" is assigned
to 'FIXED" or "FLEXIBLE."
"NAG" can be selected only when Trunk Group 'Incoming Mode (Night)" is
assigned to "FIXED."
.
If it is not assigned to "FIXED" nor 'FLEXIBLE," @-" appears in the setting
Dial Mode
DTMF Duration Time
Pulse Speed
. .
Assigns the pulse speed.
.
It is possible to assign this option only when the "Dial Mode" is set to
'Pulse." When the dial mode is set to 'DTMF," this field is blank.
% break Assigns the % break for pulse digits. This is the ratio between on and off
hook signals during digit transmission.
r: -I
CPC Detection Assigns the &xc&d minimum duration for detecting CPC (Calling Patty -'
Control) signal.
DID Start Arrangement Assigns DID start type.
When the trunk group of the line is set to 'DID", there are two methods of
initiating a call. One is immediate start where the system outpulses the
digits as soon as the trunk is seized and the other is where the system
waits for a signal (wink star&) from the far end before any digits are sent.
Conditions
field, and it is impossible to assign a destination.
Assigns the dial type (DTMF or Pulse). This is the output mode regardless
of the dial mode of the telephone used.
If Pulse is selected, refer to Section 1 O-C-51 .OO "World Select 1 (WSl )"
about the following items.
l
lnterdigit Pause
l
Pulse Type
l
% Break Detect
Assigns the duration of the DTMF tones sent.
It is possible to assign this option only when the 'Dial Mode" is set to
'DTMF. When the dial mode is set to 'Pulse," this field is blank.
Before setting this screen, "Group-Trunk Group" screen must be programmed.
This screen cannot be selected from Trunk-submenu screen, if no CO trunk card
(LCOT or GCOT or DID) is programmed in "System-Configuration", Slot Assignment.
J
If any one of the CO trunk cards is programmed, this screen can be selected.
9-F-3
(30393)