Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
17
Clean and oil the dust boots and inner fork tubes of both fork legs.
Universal oil spray (®i p. 318)
-
Press the dust boots back into their installation position.
-
Remove excess oil.
Finishing work
-
Install the fork protector, (S8 p. 17)
6.4
Removing the fork protector
Remove screws O and take off the clamp.
Remove screws
0
on the left fork leg. Take off the fork protector.
Remove screws
0
on the right fork leg. Take off the fork protector.
M
m
LH-
W&k
m
il
E00070-10
6.5
Installing the fork protector
Position the fork protector on the left fork leg. Mount and tighten screws O-
Guideline
i
10 Nm (7.4 Ibf ft)
Remaining screws, chassis
M6
m
Position the brake line, wiring harness, and clamp. Mount and tighten screws
0
Position the fork protector on the right fork leg. Mount and tighten screws
0
Guideline
MS
W
m
■ il
10 Nm (7.4 Ibf ft)
Remaining screws, chassis
M6
E00071-10
6.6
Removing the fork legs
Preparatory work
-
Raise the motorcycle with the work stand, (il p. 12)
-
Place a load on rear of vehicle.
The front wheel is not in contact with the ground.
-
Remove front wheel using a work stand. (K8 p. 101)
Main work
-
Remove screw O and P
ul1
wheel speed sensor out of the hole.
-
Remove screw
0
-
Hang the wheel speed sensor cable to the side.
-
Remove screws
0
of !
r
/
©
ff
©
©
_
D00915-10
Remove screws © and holder.
Remove screws
0
and take off the clamp.
Allow the brake caliper and brake line to hang tension-free to the side.
v
Info
Do not pull the hand brake lever when the front wheel is removed.
©
i
i
D00916-10
Advertisement
Table of Contents
