15 WIRING HARNESS, BATTERY
125
Changing the fuses of individual power consumers
15.9
Info
The fuse box containing the fuses of individual power consumers is located under the seat.
I
Preparatory work
-
Switch off the ignition by turning the ignition key to the OFF 53 position.
-
Remove the seat. (E8 p. 82)
Main work
-
Open fuse box cover O-
O
1
F00575-10
Remove the defective fuse.
Guideline
Fuse 1 - 10 A - ignition
Fuse 2 - 10 A - ignition, combination instrument, engine electronics control
unit, lambda sensor, ABS switch
Fuse 3 - 10 A - fuel pump
!^r o ^ -p
Fuse 4 - 10 A - radiator fan
Fuse 5 - 10 A - horn, brake light, turn signal, oil pressure sensor
Fuse 6 - 15 A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 7 - 10 A - for auxiliary equipment (permanent positive)
Fuse 8 - 10 A - for auxiliary equipment (accessories connected with ignition
switch)
Fuse 9 - 10 A - ABS control unit, diagnostics connector
Fuse 10 - not assigned
Fuse SPARE - 10 A/15 A - spare fuses
m
• Info
A defective fuse is indicated by a burned-out fuse wire
©
©
V/
F00576-10
Warning
Fire hazard Incorrect fuses overload the electrical system.
-
Only use fuses with the required ampere value.
-
Do not bypass or repair fuses.
A
Use spare fuses with the correct rating only.
Fuse (75011088010) (fM p. 262)
Fuse (75011088015) (@S p. 262)
• Tip
I
Replace the spare fuse in the fuse box so that it is available if needed.
-
Check that the power consumer is functioning properly.
-
Close the fuse box cover.
Finishing work
-
Mount the seat. (H p. 83)