Opening The Chain; Riveting The Chain - Husqvarna 701 Enduro 2017 Repair Manual

14 WHEELS
114
14.8.12 Opening the chain
Mount press drift
o
with the larger diameter in the spindle of the special tool.
Turn the spindle counterclockwise.
a
Chain rivet tool (60029020000) {& p. 323)
Make the connecting link of the chain accessible. Fret the riveting point.
Position the special tool with the press drift on one of the 2 pins of the connecting
link of the chain.
S Locking screw © points upwards.
Position retaining clamp
0
of the special tool on the chain from the rear.
S Markings A and B point upwards.
Slide retaining clamp
0
of the special tool into the pressing tool.
S The arrow of marking A points to locking screw ©.
Screw the locking screw hand-tight as far as it will go.
The retaining clamp is fixed.
Hold the special tool and screw in the spindle.
The chain pin is pressed out through the retaining clamp drill hole.
Unscrew the locking screw and remove the special tool.
Repeat the process on the second pin of the chain link.
203065-10
14.8.13 Riveting the chain
Grease new connecting link © and position an X-ring
0
on each pin.
Connect the chain ends with a connecting link.
Position another X-ring
0
on each pin.
O
©
a
&
©
©
203075-10
Mount press drift
o
with the smaller diameter in the spindle of the special tool.
Turn the spindle counterclockwise.
©
©
Chain rivet tool (60029020000) (£3 p. 323)
Position press plate © of the special tool on the press drift.
Position chain joint plate
0
in the press plate.
©
©
203077-10
Position the special tool on the chain.
S Locking screw
0
points upwards.
Position retaining clamp © of the special tool on the chain from the rear.
S Markings A and B point upwards.
Slide retaining clamp © of the special tool into the pressing tool.
S The arrow of marking A points to locking screw
0
Screw the locking screw hand-tight as far as it will go.
The retaining clamp is fixed.
Hold the special tool and screw in the spindle.
Press drift
©
of the special tool presses against the center of the chain joint
plate ©.
S The chain joint plate is pressed on.
Unscrew the locking screw and remove the special tool.
Rivet the two pins of the connecting link with special tool.
©
©
©Ym/
©
^Wv
203078-10
Chain rivet tool (60029020000) (£3 p. 323)