Table of Contents
Advertisement
Various Playback Operations
Fade-in'Fade-out Play
Repeat Play
Fade-in/fade-out play cannot be performed through the
digital output jack.
Fade-in Play
1
During playback or in the stop mode, press the
88 PAUSE button.
The deck enters the pause mode.
2 Press the FADER button.
The
"""« indicator flashes, and the sound fades in.
Fade-out Play
During playback, press the FADER button at the point
where you want to start fading out.
The =" | indicator flashes, and the sound being played
back fades out.
A countdown starts, and the deck enters the pause mode
after the 0.0s indicator appears.
To designate a desired duration of fade-in/fade-out
You can designate a desired duration of fade-in/fade-out.
from 1.0 seconds to 15 seconds.
Fade-in/fade-out is performed in 5 seconds unless you
designate a different duration.
If you turn off the unit after designating the desired duration
of fade-in/fade-out. the duration remains memorized.
1
Choose either
""« or =—*
by pressing the
FADER button during the stop mode.
2
Designate a desired duration by pressing the <4
or BP button.
Each time pressing the <4 or B® button. a duration
in the display changes as follows:
from 1.0 sec. to 3.0 sec.: in 0.2 sec. intervals
from 3.0 sec. to 5.0 sec.: in 0.4 sec. intervals
from 5.0 sec. to 15 sec.: in 1 sec. intervals
36
REPEAT
WALL
These functions can be performed only with the remote
commander
Playing a Selection Repeatedly
Press the REPEAT 1/ALL button on the remote
commander while the desired selection is played back.
The REPEAT 1 indicator appears
After the selection ts playback, the tape 1s rewound to the
beginning of that selection. and the playback 1s repeated
To stop playing a selection repeatedly
Press the & OPEN/CLOSE button to eject the cassete
Note on the end of the repeated portion during the REPEAT 1
play
The tape 1s rewound to the beginning of the selection to be
repeated when one of the following 1s detected
© Start ID of the next selection
¢ A blank section of more than 9 seconds
¢ End of the tape or end ID
© Skip ID with SKIP PLAY actwated
Number of times to be repeated
The selection to be repeated will be played back 5 times.
and then the tape will stop
Playing all selections repeatedly
During playback, press the REPEAT 1/ALL button until
the REPEAT ALL indicator appears on the display.
After the tape is played back to the end, it 1s rewound to the
beginning and the playback of all selections is repeated in
the RMS play (page 339). all the selections programmed are
played back repeatedly.
To stop playing all setections repeatedly
Press the & OPEN/CLOSE button to eect the cassete
Note on the end of the repeated portion during the REPEAT
ALL play
The tape 1s rewound to the beginning of the tape when the
following 1s detected
© End of the tape or end ID
¢ Ablank section of more than 9 seconds
Advertisement
Table of Contents
