Table of Contents
Advertisement
Oxolalatcvendfelats
Rear Panel Jacks
[i] LINE IN (line input) jacks (phono jack)
Connect to the recording outputs of an amplifier.
Signals supplied by the amplifier can be recorded
using the sampling frequency of 48 kHz or 44.1 kHz in
the standard play mode or 32 kHz in the long play
mode.
[2] LINE OUT (line output) jacks (phono jack)
Connect to the DAT or tape inputs of an amplifier. The
playback signal of this deck will be output.
[3] COAXIAL/OPTICAL DIGITAL IN (digital input) jacks
(coaxial phono jack/optical jack)
Connect to the digital outputs of an amplifier with a
digital output jack or another digital source such as a
CD player for digital-to-digital recording.
(4] COAXIAL/OPTICAL DIGITAL OUT (digital output)
jack (coaxial phono jack/optical jack)
Connect to the digital inputs of an amplifier having a
built-in D/A converter or another DAT deck, for
playback of a DAT cassette or digital-to-digital
recording.
[5] CONTROL-S IN jack
Connect to the CONTROL-S output of a Sony amplifier
or receiver for remote control.
Notes on connection
e Use the connecting cords specified in the illustrations.
¢ Turn off the power for all equipments before making
connections.
e Be sure to insert the plugs firmly into the jacks. Loose
connections may cause hum and noise. When
unplugging, grasp the plug and not the cord.
Notes on the optical cable
e Do not bend the cord. When the cord is not used, cur! it
with a diameter of more than 15 cm (5 7/, inches).
e Do not use it under high temperatures.
e When the optical cable is not connected, cover the
OPTICAL IN/OUT jacks with the supplied caps.
Note on sound signals
When connecting an optical cable to the DIGITAL IN/
DIGITAL OUT jacks, sound signals (L/R) are transmitted
together through the cable.
Note on the CONTROL-S IN jack
To remote control this unit through a receiver or amplifier,
connect the input of this unit to the CONTROL-S output of a
Sony receiver or amplifier, with a CONTROL-S cable. When
this connection is used, only remote control commands
sent through the receiver or amplifier will be executed. The
remote sensor of this unit will not function.
m
Advertisement
Table of Contents
