Table of Contents
Advertisement
Skip ID
When the skip ID is detected during playback, the tape
skips to the next start ID position, and the norma! playback
resumes. (See page 26 for details.)
fab diareme@leldiaremat-selgeliate|
Press the SKIP ID WRITE button at the beginning of the
portion
you want to skip later.
The| Skie ID) and WRITE indicators light momentarily.
The skip ID is written for about 1 second (2 seconds in the
long-play mode) from where you pressed the button.
Writing During Playback (Rehearsal Function)
During playback, skip ID can be written at the desired
position more accurately than during recording. Make sure
that the safety tab of the cassette is closed.
1
During playback, press the SKIP ID WRITE button
at the desired position.
The REHEARSAL indicator lights and the WRITE
indicator flashes, and the portion for 3 seconds to the
point where you pressed the SKIP ID WRITE button, is
played back repeatedly (rehearsal function).
The end of the repeated portion will be the beginning
of the skip ID.
2
Press the << or PP button to adjust the "repeat
end" point.
The "repeat end" point shifted backward with the <4
button or forward with the BP button by 0.3 of a
second.
The indicator at the MARGIN shows how much the
"repeat end" point is shifted from the point where you
pressed SKIP ID WRITE.
||
pave Gale? J
Deel
When you pressed <4 twice.
3
After setting the beginning of the skip ID at the
desired point, press the SKIP ID WRITE button
again.
The [SKIP ID] indicator lights, and the skip ID is
written.
32
BRAT
EOS ei
Note on the point where a skip ID ts written
During rehearsal function, a skip 1D will be written at the
end of the repeated portion as illustrated
Repeated portion
Pot where you pressed
SKIP 1D WRITE
Selection
Selection
Skip ID (1second)
Each time you press >>
03
03 =
sec. sec.
—<
Each time you
t——
press 44
.-—
ee
3 seconds
Normally. the repeated portion is played back 5 tmes
When the <4 or ®P button is pressed while the repeated
portion 1s played back, the repeated portion is played back
up to 8 times max, and then tape stops
Make sure that the safety tab of the cassette 1s closed
During playback or in the stop mode, press the SKIP ID
ERASE button immediately after the skip ID to be
erased.
The tape is rewound to the nearest skip ID position and the
skip ID is erased.
The ERASE indicator lights while the skip ID 1s being
searched for and goes off when the skip ID 1s erased
om ataAAt oO |
Precaution
When the skip ID and the start ID are overwnitten, the skip
ID will also be erased if the start ID is erased
Press the START 1D ERASE
button.
Press the SKIP ID ERASE
button.
Advertisement
Table of Contents
