46
en | Installing
4.7
Connecting Power Supply
Connect the power supply to the POWER 7-pin pluggable screw connector. Refer to
Connecting Diagrams, page 102 for a complete diagram of the power supply connector.
Figure 4.21: Location of the power supply connector
Figure 4.22: Location of the power supply connector
Figure 4.23: Location of the power supply connector
Connect an external power supply (10 - 14 Vdc) for the AMC2 device at pin 1 (positive) and
pin 3 (0 V) of the pluggable screw connector.
If an uninterruptible power supply (UPS) is used, the relay output for power good signals from
the UPS is connected to the following pins:
–
–
–
2020-01 | V02 |
pin 4 and 7 for power good AC
pin 5 and 7 for power good Battery
pin 6 and 7 for power good DC
Installation manual
Access Modular Controller 2
Bosch Access Systems V.B.